From 44b733809a5aba7f6b15a548d31a56d25bf3851c Mon Sep 17 00:00:00 2001 From: Mark Lord Date: Thu, 19 Aug 2010 21:40:44 -0400 Subject: [PATCH] sata_mv: fix broken DSM/TRIM support (v2) Fix DSM/TRIM commands in sata_mv (v2). These need to be issued using old-school "BM DMA", rather than via the EDMA host queue. Since the chips don't have proper BM DMA status, we need to be more careful with setting the ATA_DMA_INTR bit, since DSM/TRIM often has a long delay between "DMA complete" and "command complete". GEN_I chips don't have BM DMA, so no TRIM for them. Signed-off-by: Mark Lord Signed-off-by: Jeff Garzik Cc: stable@kernel.org --- drivers/ata/sata_mv.c | 44 ++++++++++++++++++++++++++++++++++++------- 1 file changed, 37 insertions(+), 7 deletions(-) diff --git a/drivers/ata/sata_mv.c b/drivers/ata/sata_mv.c index 9463c71dd38..81982594a01 100644 --- a/drivers/ata/sata_mv.c +++ b/drivers/ata/sata_mv.c @@ -1898,19 +1898,25 @@ static void mv_bmdma_start(struct ata_queued_cmd *qc) * LOCKING: * Inherited from caller. */ -static void mv_bmdma_stop(struct ata_queued_cmd *qc) +static void mv_bmdma_stop_ap(struct ata_port *ap) { - struct ata_port *ap = qc->ap; void __iomem *port_mmio = mv_ap_base(ap); u32 cmd; /* clear start/stop bit */ cmd = readl(port_mmio + BMDMA_CMD); - cmd &= ~ATA_DMA_START; - writelfl(cmd, port_mmio + BMDMA_CMD); + if (cmd & ATA_DMA_START) { + cmd &= ~ATA_DMA_START; + writelfl(cmd, port_mmio + BMDMA_CMD); + + /* one-PIO-cycle guaranteed wait, per spec, for HDMA1:0 transition */ + ata_sff_dma_pause(ap); + } +} - /* one-PIO-cycle guaranteed wait, per spec, for HDMA1:0 transition */ - ata_sff_dma_pause(ap); +static void mv_bmdma_stop(struct ata_queued_cmd *qc) +{ + mv_bmdma_stop_ap(qc->ap); } /** @@ -1934,8 +1940,21 @@ static u8 mv_bmdma_status(struct ata_port *ap) reg = readl(port_mmio + BMDMA_STATUS); if (reg & ATA_DMA_ACTIVE) status = ATA_DMA_ACTIVE; - else + else if (reg & ATA_DMA_ERR) status = (reg & ATA_DMA_ERR) | ATA_DMA_INTR; + else { + /* + * Just because DMA_ACTIVE is 0 (DMA completed), + * this does _not_ mean the device is "done". + * So we should not yet be signalling ATA_DMA_INTR + * in some cases. Eg. DSM/TRIM, and perhaps others. + */ + mv_bmdma_stop_ap(ap); + if (ioread8(ap->ioaddr.altstatus_addr) & ATA_BUSY) + status = 0; + else + status = ATA_DMA_INTR; + } return status; } @@ -1995,6 +2014,9 @@ static void mv_qc_prep(struct ata_queued_cmd *qc) switch (tf->protocol) { case ATA_PROT_DMA: + if (tf->command == ATA_CMD_DSM) + return; + /* fall-thru */ case ATA_PROT_NCQ: break; /* continue below */ case ATA_PROT_PIO: @@ -2094,6 +2116,8 @@ static void mv_qc_prep_iie(struct ata_queued_cmd *qc) if ((tf->protocol != ATA_PROT_DMA) && (tf->protocol != ATA_PROT_NCQ)) return; + if (tf->command == ATA_CMD_DSM) + return; /* use bmdma for this */ /* Fill in Gen IIE command request block */ if (!(tf->flags & ATA_TFLAG_WRITE)) @@ -2289,6 +2313,12 @@ static unsigned int mv_qc_issue(struct ata_queued_cmd *qc) switch (qc->tf.protocol) { case ATA_PROT_DMA: + if (qc->tf.command == ATA_CMD_DSM) { + if (!ap->ops->bmdma_setup) /* no bmdma on GEN_I */ + return AC_ERR_OTHER; + break; /* use bmdma for this */ + } + /* fall thru */ case ATA_PROT_NCQ: mv_start_edma(ap, port_mmio, pp, qc->tf.protocol); pp->req_idx = (pp->req_idx + 1) & MV_MAX_Q_DEPTH_MASK; -- 2.39.3