--- /dev/null
+Version 1.0.6 -- 03/19/2010
+ * Fix memory leak while receiving packets from unregistered VLAN.
+ * Protect vlgrp structure by pause RX actions. Instead of adding
+ lock in the hot zone.
+ * Merge new updates from mainline kernel.
+
+Version 1.0.5 -- 06/20/2009
+ * Fixed unmatched tasklet_disable and tasklet_enable pair.
+ * Allocate ring buffer information data while module initialize,
+ instead of using global space.
+ * Drop shadow register support, due to buggy hardware.
+
+Version 1.0.4 -- ??/??/2008
+ * remove unused #include <version.h>
+ By: Huang Weiyi <weiyi.huang@gmail.com>
+ * fix build error at csum_ipv6_magic()
+ By: Kamalesh Babulal <kamalesh@linux.vnet.ibm.com>
+
+Version 1.0.3 -- 10/09/2008
+ * Fixing shared IRQ problem, fixed by akeem.
+ * Add RSS_PATCH, HALF_MODE_PATCH bit setting for JMC250_rev 0x11.
+ * Added ifdef CONFIG_PM for prevent warnings with CONFIG_PM disabled.
+
+Version 1.0.2 -- 09/15/2008
+ * Modify version check for rev 11 buggy hardware.
+
+Version 1.0.1 -- 09/05/2008
+ * Removed SPI access to flash device through ioctl.
+ Will be implement with MTD block device and SPI Master in the future.
+
+Version 1.0 -- 08/29/2008
+ * Passed checkpatch.pl
+ * Passed sparse cleanly.
+ * Tested on various check that mentioned in SubmitChecklist.
+ * Supporting message level controlled by ethtool.
+ * Remove backward compatible codes.
+ (But still kept in non-mainline driver)
+ * Add pseudo hot-plug support.
+ * Fixed fragmented IP packet's TCP/UDP checksum error.
+ * Fine tune some locks, and use atomic bit operations.
+ * Add SPI interface through ioctl for flash re-programing.
+ * Fix high-loading link-down hardware reset unclean problem.
+ * Link-Change tasklet is modified to process all link-change interrupt.
+ * Fix potential racy atomic locks.
+ * Add work-arround for rev 11
+ * Add register debug human readable facilities.
+
+Version 0.9e -- 08/13/2008
+ * Fix PCC ISR handling bug.
+ * Allow PCCMTUCLR
+ * Wait phylink if PHY WoL is enabled, preventing
+ immediate resume.
+ * Default to turn on Magic Frame WoL only.
+ * Add pci_enable_wake on S1.
+ * Don't release/request IRQ on suspend/resume.
+
+
+Version 0.9d-msix -- 08/14/2008
+ * Add MSIX support.
+ * Since I still have no idea how to explicitly balance
+ the load to CPUs, the 1.0 version won't include this
+ feature.
+
+
+Version 0.9d -- 08/13/2008
+ * Fix watchdog bug.
+ * Add jmc260 support.
+
+
+Version 0.9c -- 08/11/2008
+ * Fix change mac address bug.
+ * Fix PHY Addr polling bug.
+ * Add eeprom read/write support for ethtool
+ * Add PHY Register dump for ethtool
+
+
+Version 0.9b -- 08/08/2008
+ * Add FPGA Support.
+ * Fix NAPI <-> Adaptive PCC mode switching bug.
+ * Default use Adaptive PCC mode.
+ * Modified watchdog.
+ * Support NAPI for 2.6.22 kernel
+
+
+Version 0.9a -- 08/07/2008
+ * Implement NAPI, use ethtool -C ethX adaptive-rx [on|off] to switch
+ between NAPI or Dynamic PCC mode at runtime.
+ * Fix Dynamic PCC switch bug.
+ * Pass packets with error checksum to host instead of drop.
+
+
+Version 0.9 -- 08/04/2008
+ * Implement Scatter-Gather offloading.
+ * Implement TCP Segment offloading.
+ * Pause TX queue until TX queue have sufficient space.
+ * (Saved a lot CPU)
+ * Turn on WOL by default.
+ * Setup Wakeup Frame to not possible matched pattern.
+ * Tested TCP/UDP csum over IPv4/IPv6 over VLAN all working fine! ^^
+ * Tested TSO over IPv4/IPv6 over VLAN all working fine! ^^
+
+
+Version 0.8 -- 08/02/2008
+ * Remember last link status for interface up/down.
+ * When driver loaded/unloaded and interface down, change
+ * link to 10/half force for power saving.
+ * Check MTU setting when setting tx csum.
+ * Implement VLAN offloading.
+
+
+Version 0.7 -- 08/01/2008
+ * Added Suspend/Resume support.
+ * Added Wake on LAN support.
+
+
+Version 0.6 -- 07/30/2008
+ * Use NIC Timer for dynamic PCC.
+ * Add another PCC rule for heavy error packet load.
+ * Report and set GHC when change duplex at 10/100 force mode.
+ * Implement Jumboframe.
+ * Implement MSI.
+ * Backdoor for changing "FIFO Threshold for processing next packet"
+ * Using:
+ * ethtool -C eth1 adaptive-rx on adaptive-tx on \
+ * rx-usecs 250 rx-frames-low N
+ * N := 16 | 32 | 64 | 128
+
+
+Version 0.5 -- 07/25/2008
+ * Add tx timeout watchdog.
+ * Handle PHY Force mode correctly.
+ If AN is off, mmaped PHY Status will not update, need to
+ get information using SMI.
+ Our NIC does not support 1000M Force Mode, return invalid
+ if user try to set that.
+ * Should work fine when hot-[un]pluged with pcie-hotplug driver.
+ * Record TX Collision error count on half-duplex mode.
+ * Implement tx ipv6/ip/tcp/udp checksum offloading
+ * Implement rx ipv6/ip/tcp/udp checksum offloading
+ * Add restart-AN support for ethtool.
+ * Add pause control for ethtool.
+ * Add register dump support for ethtool.
+ * Add PCC information for ethtool.
+ * Set Transmit Timer/Retry at Half Duplex Mode.
+ * Change "FIFO Threshold for processing next packet" of RXCS
+ default to 32QW (Originally 128QW)
+
+
+Version 0.4 -- 07/24/2008
+ * Support runtime change link speed.
+
+
+Version 0.3 -- 07/22/2008
+ * Clean up some code, try making it more fit to CodingStyle
+ * Add prepad cache-line optimize support.
+ * Basic RX PCC structure added.
+ * Basic TX PCC structure added.
+ * Reset PHY Processor and turn on ALL advertise by default.
+ * Rewrite TX related functions.
+ * Added 64bit address for PCI DMA support.
+ * Dynamic PCC Adjustment.
+
+
+Version 0.2 -- 07/17/2008
+ * Handle multiple RX descriptor per packet (Received a LONG packet.)
+ * Drop error RX packets, and update the counter.
+ * Using interrupt shadow register.
+ * Using sk_buff as receive buffer, NIC directly DMA to sk_buff->data.
+ * Use sk_buff kernel provided for NIC directly DMA to send packet.
+ * Use tasklet for tx desc cleanup. (Reduce ISR latency)
+ * Rearange ring data structure for CPU caching efficiency.
+ * Setup RXCS with correct values.
+ * Older(tested to 2.6.18) linux kernel support.
+ * Added a tasklet for link status change.
+ * Added a tasklet for processing incoming packets.
+ * Check DMA MRRS from pci config space, and fill TXCS.
+ * Save TXCS value in local memory, reduce register read time.
+
+
+Version 0.1 -- 07/11/2008
+ * Basic function completed.
+ * Interrupt handler and xmit function are implemented with
+ care of multiple CPU enviroment.
+ * All offload engine are not used.
+ * PCC/MSI are not used.
+ * Redudent memory copy are used. (Will be removed in the future)
+ * Acceptible performance.
+
+ Testing platform: Intel(R) Pentium(R) 4 CPU 3.00GHz
+ JMicron JMC250
+
+ Peer platforman: AMD Athlon(tm) 64 Processor 3000+
+ D-Link DGE-530T (Marvell 88E8001)
+
+ Speed CPU Usage
+ TCP tx: 7xMB 40%
+ TCP rx: 3xMB 30%
+
+ Note: These speed could be limited by peer, since CPU
+ load is not much, and queue is not full.
+
+