bool "Atmel AT91"
select ARCH_REQUIRE_GPIOLIB
select HAVE_CLK
- select ARCH_USES_GETTIMEOFFSET
help
This enables support for systems based on the Atmel AT91RM9200,
AT91SAM9 and AT91CAP9 processors.
ACTLR register. Note that setting specific bits in the ACTLR register
may not be available in non-secure mode.
+config ARM_ERRATA_742230
+ bool "ARM errata: DMB operation may be faulty"
+ depends on CPU_V7 && SMP
+ help
+ This option enables the workaround for the 742230 Cortex-A9
+ (r1p0..r2p2) erratum. Under rare circumstances, a DMB instruction
+ between two write operations may not ensure the correct visibility
+ ordering of the two writes. This workaround sets a specific bit in
+ the diagnostic register of the Cortex-A9 which causes the DMB
+ instruction to behave as a DSB, ensuring the correct behaviour of
+ the two writes.
+
+config ARM_ERRATA_742231
+ bool "ARM errata: Incorrect hazard handling in the SCU may lead to data corruption"
+ depends on CPU_V7 && SMP
+ help
+ This option enables the workaround for the 742231 Cortex-A9
+ (r2p0..r2p2) erratum. Under certain conditions, specific to the
+ Cortex-A9 MPCore micro-architecture, two CPUs working in SMP mode,
+ accessing some data located in the same cache line, may get corrupted
+ data due to bad handling of the address hazard when the line gets
+ replaced from one of the CPUs at the same time as another CPU is
+ accessing it. This workaround sets specific bits in the diagnostic
+ register of the Cortex-A9 which reduces the linefill issuing
+ capabilities of the processor.
+
config PL310_ERRATA_588369
bool "Clean & Invalidate maintenance operations do not invalidate clean lines"
depends on CACHE_L2X0 && ARCH_OMAP4
config SMP
bool "Symmetric Multi-Processing (EXPERIMENTAL)"
- depends on EXPERIMENTAL && (REALVIEW_EB_ARM11MP || REALVIEW_EB_A9MP ||\
- MACH_REALVIEW_PB11MP || MACH_REALVIEW_PBX || ARCH_OMAP4 ||\
- ARCH_S5PV310 || ARCH_TEGRA || ARCH_U8500 || ARCH_VEXPRESS_CA9X4)
+ depends on EXPERIMENTAL
depends on GENERIC_CLOCKEVENTS
+ depends on REALVIEW_EB_ARM11MP || REALVIEW_EB_A9MP || \
+ MACH_REALVIEW_PB11MP || MACH_REALVIEW_PBX || ARCH_OMAP4 ||\
+ ARCH_S5PV310 || ARCH_TEGRA || ARCH_U8500 || ARCH_VEXPRESS_CA9X4
select USE_GENERIC_SMP_HELPERS
- select HAVE_ARM_SCU if ARCH_REALVIEW || ARCH_OMAP4 || ARCH_S5PV310 ||\
- ARCH_TEGRA || ARCH_U8500 || ARCH_VEXPRESS_CA9X4
+ select HAVE_ARM_SCU
help
This enables support for systems with more than one CPU. If you have
a system with only one CPU, like most personal computers, say N. If
If you don't know what to do here, say N.
+config SMP_ON_UP
+ bool "Allow booting SMP kernel on uniprocessor systems (EXPERIMENTAL)"
+ depends on EXPERIMENTAL
+ depends on SMP && !XIP && !THUMB2_KERNEL
+ default y
+ help
+ SMP kernels contain instructions which fail on non-SMP processors.
+ Enabling this option allows the kernel to modify itself to make
+ these instructions safe. Disabling it allows about 1K of space
+ savings.
+
+ If you don't know what to do here, say Y.
+
config HAVE_ARM_SCU
bool
depends on SMP
config LOCAL_TIMERS
bool "Use local timer interrupts"
- depends on SMP && (REALVIEW_EB_ARM11MP || MACH_REALVIEW_PB11MP || \
- REALVIEW_EB_A9MP || MACH_REALVIEW_PBX || ARCH_OMAP4 || \
- ARCH_S5PV310 || ARCH_TEGRA || ARCH_U8500 || ARCH_VEXPRESS_CA9X4)
+ depends on SMP
default y
- select HAVE_ARM_TWD if ARCH_REALVIEW || ARCH_OMAP4 || ARCH_S5PV310 || \
- ARCH_TEGRA || ARCH_U8500 || ARCH_VEXPRESS
+ select HAVE_ARM_TWD
help
Enable support for local timers on SMP platforms, rather then the
legacy IPI broadcast method. Local timers allows the system