[net-next-2.6.git] / Documentation / arm / SA1100 / CERF

*** The StrongARM version of the CerfBoard/Cube has been discontinued ***

The Intrinsyc CerfBoard is a StrongARM 1110-based computer on a board
that measures approximately 2" square. It includes an Ethernet
controller, an RS232-compatible serial port, a USB function port, and
one CompactFlash+ slot on the back. Pictures can be found at the
Intrinsyc website, http://www.intrinsyc.com.

This document describes the support in the Linux kernel for the
Intrinsyc CerfBoard.

Supported in this version:
   - CompactFlash+ slot (select PCMCIA in General Setup and any options
     that may be required)
   - Onboard Crystal CS8900 Ethernet controller (Cerf CS8900A support in
     Network Devices)
   - Serial ports with a serial console (hardcoded to 38400 8N1)

In order to get this kernel onto your Cerf, you need a server that runs
both BOOTP and TFTP. Detailed instructions should have come with your
evaluation kit on how to use the bootloader. This series of commands
will suffice:

   make ARCH=arm CROSS_COMPILE=arm-linux- cerfcube_defconfig
   make ARCH=arm CROSS_COMPILE=arm-linux- zImage
   make ARCH=arm CROSS_COMPILE=arm-linux- modules
   cp arch/arm/boot/zImage <TFTP directory>

support@intrinsyc.com
Commit	Line	Data
1da177e4 LT	1	* The StrongARM version of the CerfBoard/Cube has been discontinued *
	2
	3	The Intrinsyc CerfBoard is a StrongARM 1110-based computer on a board
	4	that measures approximately 2" square. It includes an Ethernet
	5	controller, an RS232-compatible serial port, a USB function port, and
	6	one CompactFlash+ slot on the back. Pictures can be found at the
	7	Intrinsyc website, http://www.intrinsyc.com.
	8
	9	This document describes the support in the Linux kernel for the
	10	Intrinsyc CerfBoard.
	11
	12	Supported in this version:
	13	- CompactFlash+ slot (select PCMCIA in General Setup and any options
	14	that may be required)
	15	- Onboard Crystal CS8900 Ethernet controller (Cerf CS8900A support in
	16	Network Devices)
	17	- Serial ports with a serial console (hardcoded to 38400 8N1)
	18
	19	In order to get this kernel onto your Cerf, you need a server that runs
	20	both BOOTP and TFTP. Detailed instructions should have come with your
	21	evaluation kit on how to use the bootloader. This series of commands
	22	will suffice:
	23
	24	make ARCH=arm CROSS_COMPILE=arm-linux- cerfcube_defconfig
	25	make ARCH=arm CROSS_COMPILE=arm-linux- zImage
	26	make ARCH=arm CROSS_COMPILE=arm-linux- modules
	27	cp arch/arm/boot/zImage <TFTP directory>
	28
	29	support@intrinsyc.com