Make module_param and MODULE_PARAM_DESC agree on poweroff_powercycle name.
There was an extraneous ifdef in the IPMI poweroff code that prevented it from
working if PROC_FS was disabled.
Signed-off-by: Matt Domsch <Matt_Domsch@dell.com>
Signed-off-by: Corey Minyard <minyard@acm.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
/* parameter definition to allow user to flag power cycle */
module_param(poweroff_powercycle, int, 0644);
/* parameter definition to allow user to flag power cycle */
module_param(poweroff_powercycle, int, 0644);
-MODULE_PARM_DESC(poweroff_powercycles, " Set to non-zero to enable power cycle instead of power down. Power cycle is contingent on hardware support, otherwise it defaults back to power down.");
+MODULE_PARM_DESC(poweroff_powercycle, " Set to non-zero to enable power cycle instead of power down. Power cycle is contingent on hardware support, otherwise it defaults back to power down.");
/* Stuff from the get device id command. */
static unsigned int mfg_id;
/* Stuff from the get device id command. */
static unsigned int mfg_id;
rv = ipmi_smi_watcher_register(&smi_watcher);
rv = ipmi_smi_watcher_register(&smi_watcher);
if (rv) {
unregister_sysctl_table(ipmi_table_header);
printk(KERN_ERR PFX "Unable to register SMI watcher: %d\n", rv);
if (rv) {
unregister_sysctl_table(ipmi_table_header);
printk(KERN_ERR PFX "Unable to register SMI watcher: %d\n", rv);