It provides for dynamic discovery of sensors in the system and the
ability to monitor the sensors and be informed when the sensor's
values change or go outside certain boundaries. It also has a
-standardized database for field-replacable units (FRUs) and a watchdog
+standardized database for field-replaceable units (FRUs) and a watchdog
timer.
To use this, you need an interface to an IPMI controller in your
IPMI defines a standard watchdog timer. You can enable this with the
'IPMI Watchdog Timer' config option. If you compile the driver into
the kernel, then via a kernel command-line option you can have the
-watchdog timer start as soon as it intitializes. It also have a lot
+watchdog timer start as soon as it initializes. It also have a lot
of other options, see the 'Watchdog' section below for more details.
Note that you can also have the watchdog continue to run if it is
closed (by default it is disabled on close). Go into the 'Watchdog
For receiving commands, you have to individually register commands you
want to receive. Call ipmi_register_for_cmd() and supply the netfn
-and command name for each command you want to receive. Only one user
-may be registered for each netfn/cmd, but different users may register
-for different commands.
+and command name for each command you want to receive. You also
+specify a bitmask of the channels you want to receive the command from
+(or use IPMI_CHAN_ALL for all channels if you don't care). Only one
+user may be registered for each netfn/cmd/channel, but different users
+may register for different commands, or the same command if the
+channel bitmasks do not overlap.
From userland, equivalent IOCTLs are provided to do these functions.